We put the “X” in PEX pipe

We put the “X” in PEX pipe

/

Polyethylene (PE) pipe goes through the e-beam process and becomes crosslinked (X). That is how we put the “X” in PEX. Polyethylene is the most common polymer we electron beam crosslink every day. We see it in different forms, from injection molded and thermoformed parts, extruded sheet, tubing and wire and cable. While there are […]

Read more »
What is cold sterilization?

What is cold sterilization?

/

Cold sterilization may be essential for certain: pharmaceutical products medical devices tissue samples biologics For products that contain heat-sensitive ingredients and yet require sterilization or bio-reduction treatments, cold sterilization provides protection via low temperature molecular stabilization.

Read more »
What is a Lichtenberg tree?

What is a Lichtenberg tree?

/

  It has been called “trapped lightning,” but is also known as a Lichtenberg tree. We can create these Lichtenberg figures by shooting millions of electrons 99% the speed of light into the top face of an acrylic plaque. The electrons become trapped in the middle when they are absorbed within the density of the […]

Read more »
Is my product compatible with e-beam sterilization?  At what maximum dose?

Is my product compatible with e-beam sterilization? At what maximum dose?

/

  Medical device manufacturers want to know if their product is compatible with e-beam sterilization; they can do it by performing a simple experiment. This experiment includes exposing a number of samples to a range of doses to see the effects of the radiation on their product materials and the packaging. Not only will the […]

Read more »
Why use electron beam curing for reinforced plastics or composites?

Why use electron beam curing for reinforced plastics or composites?

/

With the different curing options out there, how do you know which one is best for your product? UV curing is a good method for surface treatments, however UV has limited penetration. Thermal curing may provide the answer for some thicker materials, however e-beam curing has several advantages over the thermal curing process:

Read more »
What Quality Systems are applicable for electron beam sterilization?

What Quality Systems are applicable for electron beam sterilization?

/

E-BEAM Services’ Quality Systems meets the requirements set out by the US Food and Drug Administration (FDA), and our facilities are registered and audited by the FDA. We also work with customers that market their products in Europe, so we assure compliance with the EU Guidelines to Good Manufacturing Practice for Medicinal Products and the […]

Read more »
Will crosslinking increase my plastic part’s chemical resistance?

Will crosslinking increase my plastic part’s chemical resistance?

/

You might remember from high school chemistry class that solubility is increased by chemical similarity between solute and solvent. Plastics will be most vulnerable to chemicals in which it is soluble. Therefore, you can tailor your choice of plastics so that it is resistant to a specific class of chemicals, or –very efficiently — increase […]

Read more »
How can I lower the cost per foot when processing reel-to-reel products?

How can I lower the cost per foot when processing reel-to-reel products?

/

Part 1: Why more material on a reel will result in a lower cost Sometimes more is better. More vacation days, more good weather, and, in my personal opinion, you can’t go wrong with more bacon cheesefries. The same principal also applies to the amount of material on a reel sent to us for e-beam […]

Read more »