What is chain branching?

Crosslinking of polymers via electron beam irradiation (e-beam) is  well known and the number of success stories involving it touch our daily lives in many ways – but more on that in a later blog. An important similar concept that might be a little less familiar to some is the process of chain branching.

What is chain branching? Chain branching occurs when a linear polymer is e-beamed with a minimal dose, resulting in side chains being formed, as shown in the figure below.

Chain Branching

 

In contrast, crosslinked polymers contain a matrix of branches that connect polymer chains.

Crosslinking

 

And why do you care about branching of polymers? So you can do the impossible! Because chain branching dramatically improves melt processability of linear polymers, you can down-gauge or form products in ways that otherwise wouldn’t be possible.

For example, E-BEAM ran a trial with a linear-low density polyethylene (LLDPE) for foam production.  In this case, the actual resin pellets are e-beamed prior to the extrusion process. As a control the un-beamed linear polymer was run first and came out of the extruder a molten mess, after purging the branched LLDPE was run and came out as a foam.

Un-irradiated Resin
Un-irradiated Resin

 

Irradiated Resin
Irradiated Resin

 

Polymers where chain branching has been proven (in addition to LLDPE) are polypropylene, PVdF (polyvinylidene fluoride) and PLA (polylactic acid). Have more branching questions? Submit a question or give us a call!

Featured Articles

Featured video

A video overview of how E-beam Sterilization works

Learn more about how E-BEAM Services can empower your success